HYDRAULIC MODELING AND OPTIMIZATION OF WASTE STABILIZATION POND DESIGN FOR DEVELOPING NATIONS
No Thumbnail Available
Date
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
Description
Wastewater stabilization ponds (WSPs) have been identified and are used extensively to
provide wastewater treatment throughout the world. It is often preferred to the
conventional treatment systems due to its higher performance in terms of pathogen
removal, its low maintenance and operational cost. A review of the literature revealed that
there has been limited understanding on the fact that the hydraulics of waste stabilization
ponds is critical to their optimization. The research in this area has been relatively limited
and there is an inadequate understanding of the flow behavior that exists within these
systems. This work therefore focuses on the hydraulic study of a laboratory-scale model
WSP, operated under a controlled environment using computational fluid dynamics (CFD)
modelling and an identified optimization tools for WSP.
A field scale prototype pond was designed for wastewater treatment using a typical
residential institution as a case study. This was reduced to a laboratory-scale model using
dimensional analysis. The laboratory-scale model was constructed and experiments were
run on them using the wastewater taken from the university wastewater treatment facility.
The study utilized Computational Fluid Dynamics (CFD) coupled with an optimization
program to efficiently optimize the selection of the best WSP configuration that satisfy
specific minimum cost objective without jeopardizing the treatment efficiency. This was
done to assess realistically the hydraulic performance and treatment efficiency of scaled
WSP under the effect of varying ponds configuration, number of baffles and length to
width ratio. Six different configurations including the optimized designs were tested in the
laboratory to determine the effect of baffles and pond configurations on the effluent
characteristics. The verification of the CFD model was based on faecal coliform
inactivation and other pollutant removal that was obtained from the experimental data.
The results of faecal coliform concentration at the outlets showed that the conventional
70% pond-width baffles is not always the best pond configuration as previously reported
in the literature. Several other designs generated by the optimization tool shows that both
shorter and longer baffles ranging between 49% and 83% for both single and multiobjective
optimizations could improve the hydraulic efficiency of the ponds with different
variation in depths and pond sizes. The inclusion of odd and even longitudinal baffle
arrangement which has not been previously reported shows that this configuration could
improve the hydraulic performance of WSP. A sensitivity analysis was performed on the
model parameters to determine the influence of first order constant (k) and temperature
(T) on the design configurations. The results obtained from the optimization algorithm
considering all the parameters showed that changing the two parameters had effect on the
effluent faecal coliform and the entire pond configurations.
This work has verified its use to the extent that it can be realistically applied for the
efficient assessment of alternative baffle, inlet and outlet configurations, thereby,
addressing a major knowledge gap in waste stabilization pond design. The significance of
CFD model results is that water and wastewater design engineers and regulators can use
CFD to reasonably assess the hydraulic performance in order to reduce significantly faecal
coliform concentrations and other wastewater pollutants to achieve the required level of
pathogen reduction for either restricted or unrestricted crop irrigation.
Keywords
TA Engineering (General). Civil engineering (General)